HQ Delta Hawk repair

    Hello,
    I have found an old HQ delta Hawk and I want to restore it, I have two questions:
    which kind of center T I have to use? Center T is lost, and the lower spreader is 1 piece
    I have downloaded the manual from the HQ website, and the bridle is attached on the upper spreader connector, in my Delta Hawk the upper bridle is on the spine, would be better to update the bridle?
    Standoff are missing, but I have found measures in the manual.


    Thanks for your help, kind regards.



    Hi Tullo,


    If I remember correctly the center "T" was a rubber O-ring. I would leave the bridle setup as it is. The only thing I would remove are those metal rings. You should replace them with rope ends. If the bridle is very old and brittle you should replace it completely.


    Wishing you much success with your restoration.

    Zitat von Mark O2

    Hi Tullo,


    If I remember correctly the center "T" was a rubber O-ring. I would leave the bridle setup as it is. The only thing I would remove are those metal rings. You should replace them with rope ends. If the bridle is very old and brittle you should replace it completely.


    Wishing you much success with your restoration.

    Thanks a lot!!